glenn bradley
06-26-2009, 9:38 PM
I couldn't find the post where I mentioned this so here you go whoever it was that asked. A 2-1/2" wye with one leg enlarged on the inside diameter to fit a shop vac (use the spindle sander for this . . . duh), a rubber coupler from the BORG and some flex hose.
121716
Goes together like so:
121717
I have a few tools in this part of the shop that trigger the shop vac. I just move the hose from machine to machine. The rigid flex really allows you to get in close without touching the abrasive:
121718
Another view:
121719
Slips off for storage along with the sander in the cabinet:
121720
121716
Goes together like so:
121717
I have a few tools in this part of the shop that trigger the shop vac. I just move the hose from machine to machine. The rigid flex really allows you to get in close without touching the abrasive:
121718
Another view:
121719
Slips off for storage along with the sander in the cabinet:
121720