Lewis Cobb
06-23-2009, 7:50 PM
So the user manual says access to the 45 degree blade stop can be gained though the hole on the front of the saw where the blade height wheel is......
Yea, right. While I can see it clearly though the hole, I have yet to find a wrench in my toolbox that I can fit in there to get to the jam nut and loosen it so I can tweak the stop a bit.
I might be missing something obvious here (wouldn't be the first time) so be gentle in your responses :D
I am just shy of getting the blade to 45 degrees which is why I want to adjust it. I never trust these stops anyway, but in this case the stop is "stopping" too soon.
Thanks for any pointers people can pass along.
Cheers,
Lewis
Yea, right. While I can see it clearly though the hole, I have yet to find a wrench in my toolbox that I can fit in there to get to the jam nut and loosen it so I can tweak the stop a bit.
I might be missing something obvious here (wouldn't be the first time) so be gentle in your responses :D
I am just shy of getting the blade to 45 degrees which is why I want to adjust it. I never trust these stops anyway, but in this case the stop is "stopping" too soon.
Thanks for any pointers people can pass along.
Cheers,
Lewis