View Full Version : Mag jig router table fence??
Jason White
06-23-2009, 7:46 PM
Anybody use mag jigs to make a router table fence for a cast-iron tablesaw top?
Jason
harry strasil
06-23-2009, 9:16 PM
almost my table top is 3/16 sheet, I built it long ago.
Myk Rian
06-23-2009, 9:40 PM
I understand the mags have a tendency to slide. Their real value being in not lifting up.
Mark Carlson
06-23-2009, 10:15 PM
I use them to hold down an incra fence on a steel router table extension. I got some slippage until I glued sand paper to the bottom of the board. Now it wont move no matter how much lateral force I apply. Note only two are really needed and screwed in. The other two live in the holes until I need them for feather board jigs.
http://www.sawmillcreek.org/attachment.php?attachmentid=106234&d=1231385772
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.