Mag jig router table fence??

[Jason White]

Anybody use mag jigs to make a router table fence for a cast-iron tablesaw top?

Jason

[harry strasil]

almost my table top is 3/16 sheet, I built it long ago.

[Myk Rian]

I understand the mags have a tendency to slide. Their real value being in not lifting up.

[Mark Carlson]

I use them to hold down an incra fence on a steel router table extension. I got some slippage until I glued sand paper to the bottom of the board. Now it wont move no matter how much lateral force I apply. Note only two are really needed and screwed in. The other two live in the holes until I need them for feather board jigs.

http://www.sawmillcreek.org/attachment.php?attachmentid=106234&d=1231385772