Pencil Sharpener Inlay system.

[Steve Garrison]

I remember about 10 or 15 years ago seeing an advertisement for a special drill bit that drilled a tapered hole that matched the angle of a pencil sharpened point. It was used to make small circular inlays by drilling the tapered hole, using a pencil sharpener to put a point on a dowel, glue the sharpened point into the hole and saw it off and sand flush. The resulting inlay could be made different sizes depending on the depth of the hole. I can't seem to find it anywhere now, does anyone know where I could find one of these?

[sean m. titmas]

they are sold in either the Lee Valley, Woodworker Pro, or Vertias catalogs.

[Steve Garrison]

Thanks Sean, I didn't think to look in Canada.

[William Hutchinson]

Is this what your looking for?

http://www.veritastools.com/Content/Assets/ProductLarge/EN/05J1401L.jpghttp://www.veritastools.com/Content/Assets/ProductSmall/EN/05J1401S1.jpg


http://www.veritastools.com/Products/Page.aspx?p=152