View Full Version : Engraving Tinplates
Andrea Weissenseel
05-29-2009, 1:47 AM
has anyone engraved tinplates with the laser ? I would think using Thermark will work :confused:
Frank Corker
05-29-2009, 5:36 AM
I tried a piece of tin once, just to see, but the result was very poor.
Dan Hintz
05-29-2009, 7:36 AM
I don't know how thick the average tinplate is, but if it's too thin the Cermark/Thermark marking process is probably going to put too much heat into the substrate and warp it.
James Stokes
05-29-2009, 7:57 AM
I engraved a bunch of tin cups using the lmm2000 it worked pretty good but the lmm14 would have worked better.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.