Dennis Puskar
05-28-2009, 11:48 PM
How do you cut diamond shapes out of face grain stock ?
Dennis
Malcolm Tibbetts
05-29-2009, 1:24 AM
Dennis, here's one way. Rip a board to a given width. Set the miter angle on a chop saw at say 30 degrees (sharper angle will give you more pointed diamonds). Make a miter cut at one end of the board. Clamp a stop block, do a test cut, adjust the stop block until all four sides are equal, then proceed to cut away.
Dennis Puskar
05-29-2009, 4:17 PM
Thank you very much Malcolm I will do that later on.
Dennis
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.