Power feed for resaw

[Michael Bock]

I'm looking at the Grizzley resaw power feed units and would like the larger one, but I need slower feed speeds. My resaw is a Hitachi CB 1000 and I'm wondering if the smaller one mentioned by Dennis Perry can be used, perhaps mount it higher so that it pushes against the material more in the center?
Anybody have any more experience with these feeders or slowing down feed rates?

Thanks, Michael Bock

[Rod Sheridan]

Michael, what feed rate are you looking for?

The Grizzly feeder you mentioned goes down to 4.4 feet per minute.

The Comatic variable speed AF120N has a range of .6 to 20 m/Minute at 50 Hz which would be .72m/Minute at 60Hz.

Regards, Rod.