View Full Version : router bit storage
Mark Valsi
05-28-2009, 9:01 AM
AFter a couple years of total chaos in the router bit drawer, I came up with this solution.
Holes were cut with a Forstner bit.
The pics are not so hot, taken with an iPhone and I shake a bit.
You can see that i put the micrometer on each bit to get exact diameter.
Lee Koepke
05-28-2009, 10:29 PM
I used an old uhmw cutting board. not good for labeling like yours, but easy in, easy out.
I screwed a couple of scraps under to lift it off the drawer some.
John Lucas
05-29-2009, 8:31 AM
Mark,
Pure and simple - does it for me. I have similalr but width of router table. It is a drawer under the open space. I have not taken time to mark them all but I like your system.
Drawer below that stores all the nicely boxed sets.
I have only the orange color bits.
Prashun Patel
05-29-2009, 8:57 AM
Thanks. I'm just reaching the point of bit chaos, and this solution fits the bill.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.