onur cakir
05-27-2009, 8:35 AM
Hi Everyone ! Hope you all are ok !
Is is possible to calculate cutting time before the job ?
I need to know 2 parametres for that:
-Total line length for complex drawings. Is it possible to see this in corel ?
-Speed by givin %. Like if my Epilog cuts .... mm length in %100 speed so that will cut .... mm in %6 speed.
Attached you can find an expample drawing for finding its total length.
Thank you
Is is possible to calculate cutting time before the job ?
I need to know 2 parametres for that:
-Total line length for complex drawings. Is it possible to see this in corel ?
-Speed by givin %. Like if my Epilog cuts .... mm length in %100 speed so that will cut .... mm in %6 speed.
Attached you can find an expample drawing for finding its total length.
Thank you