Brad Ridgway
05-26-2009, 6:07 PM
Well i didn't plan ahead with this one... This thing is a beast in a small shop. It's rear fence (not to mention the on/off enclosure) are higher than my table saw, bench, etc...
Anyone else struggle with this when trying to figure out where to put it? The best place i can think of would be against one of my walls, but that's where my bench is and i hate to give that location up. (as the bench would have to become my outfeed table).
-brad
p.s. i once posted a thread about trying to remove /move the switch, but with the high fence, i'm stuck even if i did come up with a solution there...
Anyone else struggle with this when trying to figure out where to put it? The best place i can think of would be against one of my walls, but that's where my bench is and i hate to give that location up. (as the bench would have to become my outfeed table).
-brad
p.s. i once posted a thread about trying to remove /move the switch, but with the high fence, i'm stuck even if i did come up with a solution there...