Greg Bender
05-21-2009, 9:36 PM
I've got a Black & Decker/Dewalt 16" Radial Arm that had a 230 volt electronic blade brake that was accidentally wired to a 460 volt circuit and got fried.It was disconnected from the saw with no attention paid to where all the wires were located.I want to run the saw without the brake but I'm missing one side of the coil and have a wire coming off a aux contact that I do not know what it's purpose is.
Does anybody have a saw like this or the schematic for one that can offer some assistance.I need it running and do not know where to start especially using 460 volt power,not the stuff to experiment with.The saw is a 5 hp 460 volt,3 phase model number T-1853-typeAA and the serial number is 569340.Any help will be really appreciated.
Greg
Does anybody have a saw like this or the schematic for one that can offer some assistance.I need it running and do not know where to start especially using 460 volt power,not the stuff to experiment with.The saw is a 5 hp 460 volt,3 phase model number T-1853-typeAA and the serial number is 569340.Any help will be really appreciated.
Greg