Dell Moore
05-12-2009, 2:54 PM
I spent the morning lining up and drilling to put the fence on my new unisaw. Everything used, and the previous owner did things bass ackwards.
I used my smaller biesemeyer to estimate everything I did on this one, but I'll be danged if when it was all said and down the fence itself did ride up a good quarter of an inch or so off the tabletop. I didn't notice it until I was across the room and looking back at the saw.
Do you think this is going to be a huge problem? I really detest the idea of drilling the caste iron again. I often us a sacrificial fence also...
Any thoughts? Drill again, right? :mad:
Thanks,
Dell
I used my smaller biesemeyer to estimate everything I did on this one, but I'll be danged if when it was all said and down the fence itself did ride up a good quarter of an inch or so off the tabletop. I didn't notice it until I was across the room and looking back at the saw.
Do you think this is going to be a huge problem? I really detest the idea of drilling the caste iron again. I often us a sacrificial fence also...
Any thoughts? Drill again, right? :mad:
Thanks,
Dell