Dan Park
05-11-2009, 12:33 PM
Hello Everyone:
I'm new to the forum and would like to get your advice on how to etch a seal that is round. I have a Epilog 45 watt helix w/ the rotary attachement and I'm etching a pint glass.
The etch comes out oval, I've slowed the machine down to 20% thinking it was slipping, but the result is the same. Any one run into this issue? and how did you fix?
Regards,
Dan
dan@danpark.com
I'm new to the forum and would like to get your advice on how to etch a seal that is round. I have a Epilog 45 watt helix w/ the rotary attachement and I'm etching a pint glass.
The etch comes out oval, I've slowed the machine down to 20% thinking it was slipping, but the result is the same. Any one run into this issue? and how did you fix?
Regards,
Dan
dan@danpark.com