Powermatic #400 Mortiser

[Richard Mullin]

I need help! I just bought one of these in very good condition, but it is missing the three spoke wheel (like on drill presses) for the rack and pinion. If someone could send me a sketch of the three spoke wheel (especially the hub) I can make a new one. Even photos with a few dimensions would help.

[harry strasil]

You should be able to contact Powermatic and ask for a users manual and a parts list, which will show a breakdown of the parts. I am assuming its just a round shaft with the teeth milled into the center and a hole for the handle with a set screw to hold it in place.

[Rod Upfold]

Here is a lead with a name that you can ask...but you will have to join the owwm to ask...


http://www.owwm.com/photoindex/detail.aspx?id=2568



Rod