Eric Jackson
04-23-2009, 9:35 PM
Hello fellow Creekers,
After doing alot of wood plaques lately, I had to move on to doing dome acrylic engraving and vectoring. My problem came at not getting the best results on the Acrylic.
I couldn't figure it out. Then it came to me...CLEAN YOUR MACHINE!!
It was amazing!!!!! The machine actually did what it was supposed to do, and it came out great. So for all of you out there who does not keep a scheduled cleaning, take time to clean those optics, mirrors, and grease those rails.
I don't know about you, but I paid too much for my machine only to have my lack of cleanliness to cost me a fortune later.
Just wanted to pass on what I learned!:)
After doing alot of wood plaques lately, I had to move on to doing dome acrylic engraving and vectoring. My problem came at not getting the best results on the Acrylic.
I couldn't figure it out. Then it came to me...CLEAN YOUR MACHINE!!
It was amazing!!!!! The machine actually did what it was supposed to do, and it came out great. So for all of you out there who does not keep a scheduled cleaning, take time to clean those optics, mirrors, and grease those rails.
I don't know about you, but I paid too much for my machine only to have my lack of cleanliness to cost me a fortune later.
Just wanted to pass on what I learned!:)