Worksharp Stand and Storage

[glenn bradley]

I got an email from Wood Magazine with a contributor sharing a storage box he made for his Worksharp. My WS is OK but the suppplies were always getting shuffled about. I didn't have the room for a box the size of his so, factoring in the three golden rules of shop fixtures around here:

- What is it supposed to do?
- Where will it go once its built?
- What do I have handy to make it out of?

I built this.

116048

It is designed to be gripped by bench dogs and to fit in here when it is not in use.

116049

[Jim Kountz]

Now thats a great solution Glenn. I have the same problem with all the pieces that go with the WS. Discs, glass plates etc. I just may have to copy some of your ideas there!!

[glenn bradley]

Just in case it helps anyone, here's the 15* ramp setup for the drawer that allowed me to squeeze stuff into the size I needed.

[Stephen Edwards]

That looks very nice Glenn, in addition to being a great solution.

I shall remember all three of your Golden Rules. I've been using rule number three on your list for years. Your rule number two is the one I need to work on!

[glenn bradley]

Your rule number two is the one I need to work on!

Amen brother. I struggle with it all the time. A variation is "Where will I put this new TOYL when I get it home?" :D:D:D