View Full Version : Lathe stand finished
Gary Kvasnicka
04-11-2009, 9:14 PM
I finally cleaned off my table saw top and finished my lathe stand. The top of this stand is a paralam beam that the lathe's previous owner gave me when I bought the lathe. The base is laminated pine lumber from the borg.
Ken Fitzgerald
04-11-2009, 9:33 PM
Gary....Nicely done bench! I need to do something similar for storage under my lathe. Nicely done!
Ron McKinley
04-11-2009, 9:58 PM
Looks like you've got the extension too. That's what I need just to get the tailstock out of the way.
Very nice cabinet. I'm sure you will enjoy it....Ron
Steve Schlumpf
04-11-2009, 10:22 PM
Gary - very nice work! You put a lot of thought into the design - looks like it should work out very well for you! Seriously nice work!
alex carey
04-11-2009, 10:48 PM
Great looking stand, looks plenty sturdy.
Mike Stephens
04-12-2009, 7:46 AM
Very sweet set up Gary.
Enjoy it.
Mike
Skip Spaulding
04-12-2009, 7:51 AM
Very nice Gary, I like the well organized setup.
Alan Trout
04-12-2009, 10:25 AM
Nicely done Gary, Great work!
Alan
Bernie Weishapl
04-12-2009, 10:29 AM
Great looking bench Gary. Nicely done.
Jeff Nicol
04-12-2009, 5:48 PM
Gary, That is a bench to be proud of! Looks better than some of the cabinets in houses I lived in when I was a young bachelor! Keep up the good work, it becomes you!
Jeff
Mark Norman
04-13-2009, 12:16 AM
SWEET!
now go turn something! :p
Tim Cleveland
04-13-2009, 5:46 PM
Nice stand. I really like the storage space and tool rack that you incorporated into it. I have a Nova 1624 and have been planning on building a stand for it for a while and I really like the looks of this one. Have you had a chance to use it yet, and if so, how well does it dampen vibration? About how much does it weigh?
Tim
Jim Kountz
04-13-2009, 7:05 PM
Nice setup!! Looks like that oughta work out great!!
Bruce Shiverdecker
04-13-2009, 9:44 PM
Looks like you got everything right where you want it.
Bruce
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.