travis howe
04-10-2009, 7:52 PM
I've noticed recently I'm not square on my cuts. I have the Incra5000 cc sled that has been dead on for some time.
So after an hour of messing w/ the miter sled I realized it had to be something different. What I found was that the blade was out of alignment with the table so as I pushed a piece through I would get a gap on the outward edge, creating a little more than 1/8" difference from one side to another on a 12" board.
I figured out how to move the entire blade setup and have gotten it much closer but still a little off but the adjustments now don't seem to be doing much for me. Is there something stupid I'm missing here?
Cheers!
So after an hour of messing w/ the miter sled I realized it had to be something different. What I found was that the blade was out of alignment with the table so as I pushed a piece through I would get a gap on the outward edge, creating a little more than 1/8" difference from one side to another on a 12" board.
I figured out how to move the entire blade setup and have gotten it much closer but still a little off but the adjustments now don't seem to be doing much for me. Is there something stupid I'm missing here?
Cheers!