Dean Ousterhout
04-09-2009, 7:10 AM
Hello all,
I am new to the site and appreciate any suggestions. I just picked up a used Unisaw with a 52" Unifence and have read tons about how to "tune" the saw. I am currently sanding the top and all the suggestions for getting rid of light surface rust are working great.
I am not ready yet, but thinking about it... the install of the fence... and after reading the instructions, I noticed that my unifence is different from the instructions I downloaded from Delta.
My fence does not have the t-channel for the bolts. Mine has pre-drilled holes and the holes where the extension table mounts do not have bolts in them.
Any thoughts as to how I get bolts into the empty holes. There must be a way... this is too well made a saw to not have a system... I figured you folks would know all the secrets... :)
Thanks for all the help... especially all the posts that detail how to take care of your saw... and how to get it ready for years of use...
Dean
I am new to the site and appreciate any suggestions. I just picked up a used Unisaw with a 52" Unifence and have read tons about how to "tune" the saw. I am currently sanding the top and all the suggestions for getting rid of light surface rust are working great.
I am not ready yet, but thinking about it... the install of the fence... and after reading the instructions, I noticed that my unifence is different from the instructions I downloaded from Delta.
My fence does not have the t-channel for the bolts. Mine has pre-drilled holes and the holes where the extension table mounts do not have bolts in them.
Any thoughts as to how I get bolts into the empty holes. There must be a way... this is too well made a saw to not have a system... I figured you folks would know all the secrets... :)
Thanks for all the help... especially all the posts that detail how to take care of your saw... and how to get it ready for years of use...
Dean