Martin Boekers
03-31-2009, 12:45 PM
I have been having issues with my Epilog.
Getting a "dropout" on smaller type
If i have 6 or 8 point type (Times New Roman)
on a lower case y yhe area between the "V" (top of the y"
and the dot on the tail dissappears.
I have replaced the "X" motor the PCB board, the encoder strip and now the laser.
I have a newer "twin to this laser about a year old" and it engraves this detail perfectly.
The laser I'm having issues with is about 6 years old, but it worked fine until last month and now I'm on a journey to get it back up and running.
Sooooooo.... what help I need if any one has a 75 EXT if the would run a test of a line of Times New Roman lower case y's at 6 & 8 points at 100 sp 35 power on laser brass and let me know if they have nicely formed y's or y's with drop outs.
This will much be appreciated!!!!!
Marty
Getting a "dropout" on smaller type
If i have 6 or 8 point type (Times New Roman)
on a lower case y yhe area between the "V" (top of the y"
and the dot on the tail dissappears.
I have replaced the "X" motor the PCB board, the encoder strip and now the laser.
I have a newer "twin to this laser about a year old" and it engraves this detail perfectly.
The laser I'm having issues with is about 6 years old, but it worked fine until last month and now I'm on a journey to get it back up and running.
Sooooooo.... what help I need if any one has a 75 EXT if the would run a test of a line of Times New Roman lower case y's at 6 & 8 points at 100 sp 35 power on laser brass and let me know if they have nicely formed y's or y's with drop outs.
This will much be appreciated!!!!!
Marty