Jeremy Treibs
03-30-2009, 8:39 PM
Greetings,
I searched and seached, but alas I could not find the thread where the fellow Creeker had rigged an insert into his Grizzly G1071 oss. It looked as if it could only be used when the table was perpendicular to the spindle and made of plywood.
Does anyone know what I am talking about / have the dimentions for that?
Thanks!
J
I searched and seached, but alas I could not find the thread where the fellow Creeker had rigged an insert into his Grizzly G1071 oss. It looked as if it could only be used when the table was perpendicular to the spindle and made of plywood.
Does anyone know what I am talking about / have the dimentions for that?
Thanks!
J