John W Kidd
03-26-2009, 6:28 PM
Sorry for the newbie question but my resident expert is on vacation. I was trying to engrave a name into a plastic pelican flashlight today but I was unable to set the height of the flashlight. I did lower the table but when I tried to allow for the 1.5" height of the flashlight I was unable to select custom in fixture type. I believe that I was shown that the place to set this was in (fixture type, universal control panel under settings). So long story short when I said go, the table bed rose up and knocked the flash light over.
So long story short how do I get the program to let me select a different fixture type. The program at this time will not allow me to select it, but earlier today my tech showed me that he could do it.
John Kidd
So long story short how do I get the program to let me select a different fixture type. The program at this time will not allow me to select it, but earlier today my tech showed me that he could do it.
John Kidd