Josh Satterlee
03-24-2009, 6:43 PM
Total Newbie question:
I wanted to replace the crank handles on my C-man 113.29992 tablesaw. So I measured the shaft as 1/2" and ordered new cast steel ones on closeout from the Big Green Bear (Grizzly). Woo-hoo, I said.... Only $4.50!!! Yippee!
In preparation of my order arriving, I THEN took off the original handle, which revealed a step-down to a 3/8" shaft. Since they are closeout, the new cast ones can't be returned. So here is the question:
Can anyone think of some way to add 1/8" (of diameter)to my shaft (keep it clean here...)? I was thinking of maybe a steel roll pin, but I can't find a 1/2" diameter, 1/16th walled roll pin.
Thanks in advance.
I wanted to replace the crank handles on my C-man 113.29992 tablesaw. So I measured the shaft as 1/2" and ordered new cast steel ones on closeout from the Big Green Bear (Grizzly). Woo-hoo, I said.... Only $4.50!!! Yippee!
In preparation of my order arriving, I THEN took off the original handle, which revealed a step-down to a 3/8" shaft. Since they are closeout, the new cast ones can't be returned. So here is the question:
Can anyone think of some way to add 1/8" (of diameter)to my shaft (keep it clean here...)? I was thinking of maybe a steel roll pin, but I can't find a 1/2" diameter, 1/16th walled roll pin.
Thanks in advance.