Doug Skyer
03-16-2009, 10:07 PM
I am looking for jig plan to cut angles from 0-45 degrees on the edge of wide boards on a table saw with the blade in the 90 degree position. I saw a video with one a couple weeks back but did not bookmark it. The jig had a large adjustable table that you could clamp wide boards to. What I liked about the jig was that you could cut a 45 in the end of a board, then flip it over and cut a spline in the face you just cut. I just can not figure out were I saw it. Anyone else see this and can remember where?
thanks
-doug
thanks
-doug