Jig for Cutting Angles on Table Saw

[Doug Skyer]

I am looking for jig plan to cut angles from 0-45 degrees on the edge of wide boards on a table saw with the blade in the 90 degree position. I saw a video with one a couple weeks back but did not bookmark it. The jig had a large adjustable table that you could clamp wide boards to. What I liked about the jig was that you could cut a 45 in the end of a board, then flip it over and cut a spline in the face you just cut. I just can not figure out were I saw it. Anyone else see this and can remember where?

thanks

-doug

[Jerome Hanby]

Not sure about the spline part, but the description sounds a little like a Dubby. Just google it.

[Michael Weber]

My interpretation of what the OP is looking for is something that will cut an angle along the edge of a board, not across the board like making a picture frame. Something to hold the wood at an angle to the table top not at an angle to the blade. Is that correct?