PDA

View Full Version : Marco Laserable Crystal??



Bob Cole
03-11-2009, 8:07 PM
Have any of you used this? I was curious how well it turns out on a laser.

I am fine tuning my glass technique and sorry to say my scrap pile is getting larger. And wondering if I am going to have the same issue with laser crystal. Since the blanks are more expensive than the glass, I may have to take out a loan for all the scrap I'm going through :)

The item in question is on pg 122 of the Discount Trophy / Marco catalog item number CRY241.

I am looking at adding sandblasting to my list of items of mass destruction but currently am not setup for it.

Bill Cunningham
03-12-2009, 9:01 PM
What are you trying to etch 'onto' the glass?

Bob Cole
03-13-2009, 11:40 AM
There will be a logo and text for a years of service award.

Paul Brinkmeyer
03-13-2009, 12:45 PM
I have done the CRY243 on the same page, and it turned out good.
Just used the same settings I use on glass.

Martin Boekers
03-13-2009, 3:25 PM
I do bases from the CRY 115 series all the time they engrave well and are consitant.

I hit them at 100 sp 85 pwr 1200 freq with Epilog 75 watt

bases must be hand polished as bevels aren't always consitant.


Marty