Peter Meacham
03-06-2009, 2:29 PM
I am making a pair of dice from 2" crystal glass cubes from Marco (product CRY91) for a trophy.
Any suggestions on how to darken (paint) the spots after lasering them? They really don't show up too well without darkening them somehow.
I tried some black Pro Laser Fill from Laserbits, but I guess because the glass is not porous, the fill did not really stick to the glass and make much difference in the appearance.
Should the steps be (1) Mask, (2) engrave, (3) paint. If so, what mask and paint would you use.
Thanks for any suggestions.
Pete
Any suggestions on how to darken (paint) the spots after lasering them? They really don't show up too well without darkening them somehow.
I tried some black Pro Laser Fill from Laserbits, but I guess because the glass is not porous, the fill did not really stick to the glass and make much difference in the appearance.
Should the steps be (1) Mask, (2) engrave, (3) paint. If so, what mask and paint would you use.
Thanks for any suggestions.
Pete