Antonio Robbins
03-03-2009, 11:46 AM
Hello everyone, I found this forum searching for some info, which is surprisingly vague on the engraving manufacturers websites. :)
I work for a company using a 3.5 30watt VersaLASER. We engrave drives, wood, etc, but one thing we've considered is engraving iPods. What power strength would be needed for engraving such devices?
(We have Cermark, but we've NEVER been able to get a successful engraving from it.)
Also on a separate note I've long wanted to get a laser for personal use, but there's no way I could afford a $10k unit. I've been seeing some chap units from China going for around $1k - $2k. anyone know if they're any good?
(or if any have a larger then 10" area?)
Thanks for any info!
Antonio
I work for a company using a 3.5 30watt VersaLASER. We engrave drives, wood, etc, but one thing we've considered is engraving iPods. What power strength would be needed for engraving such devices?
(We have Cermark, but we've NEVER been able to get a successful engraving from it.)
Also on a separate note I've long wanted to get a laser for personal use, but there's no way I could afford a $10k unit. I've been seeing some chap units from China going for around $1k - $2k. anyone know if they're any good?
(or if any have a larger then 10" area?)
Thanks for any info!
Antonio