PDA

View Full Version : Shaper Insert Cutter Head


CPeter James
03-02-2009, 10:18 PM
I have a new-to-me Delta HD Shaper. I also have about 10 or 15 sets of insert knives for a Craftsman Molding head. Does anyone make a shaper head to use these knives?

http://s7.sears.com/is-viewers/dhtml/images/blankimg.gif
Bob Wingard
03-03-2009, 12:40 AM
Woodmaster makes one to fit their molder/planer .. .. don't see why it wouldn't work if the shaft size is the same.
Rod Sheridan
03-03-2009, 8:57 AM
I have a new-to-me Delta HD Shaper. I also have about 10 or 15 sets of insert knives for a Craftsman Molding head. Does anyone make a shaper head to use these knives?

http://s7.sears.com/is-viewers/dhtml/images/blankimg.gif

I haven't seen a head that uses the Craftsman knives.

The two most common sizes for insert knives are 40 and 50mm, such as the CMT/Amana/Dimar etc.

Regards, Rod.
Paul Johnstone
03-04-2009, 10:19 AM
I have a new-to-me Delta HD Shaper. I also have about 10 or 15 sets of insert knives for a Craftsman Molding head. Does anyone make a shaper head to use these knives?

http://s7.sears.com/is-viewers/dhtml/images/blankimg.gif

I assume you are talking about a shaper head that can use the table saw molding knives.. I see these on ebay from time to time. I don't know if they are compatible with the craftsman tablesaw molding knives or not, but there are some out there.