Chris Harry
03-01-2009, 9:57 AM
Looking at my Delta 28-276 bandsaw, I noticed that where the 2 frame halves meet (at the really big bolt), the halves arent square to each other...the rear lines up but the front is off by about 3/16".
My question is if I should loosen the bolt and align them correctly. I think i should, as I think it might be affecting the tracking of the blade (blade rides more on the outside of the lower wheel while perfectly centered on the upper wheel).
Figured Id ask, as Ive never seen this referenced anywhere
My question is if I should loosen the bolt and align them correctly. I think i should, as I think it might be affecting the tracking of the blade (blade rides more on the outside of the lower wheel while perfectly centered on the upper wheel).
Figured Id ask, as Ive never seen this referenced anywhere