Chris Konikowski
02-28-2009, 5:08 PM
OK, I thought my allignment was just not holding, but now I discovered something. If I put the a-line it deal at the front (nearest to the operator) side of the blade and zero the indicator, then raise and lower the blade, I get about .004 play. If I do the same on the back side of the blade, I get about .014" play. I really don't need to raise the blade, just barely start to move the blade up or down...really just load the gears one way or the other.
What the hell is going on here. Did I get screwed when I picked this saw up or is this something I can tighten or adjust?
I am at a loss here. I am in desperate need of help.
I am willing to pay someone to come help me allign this saw or diagnose the issue. I don't know what a fair price would be, but let me know what it should be....:(
BTW, I am in Houston-NW side...
What the hell is going on here. Did I get screwed when I picked this saw up or is this something I can tighten or adjust?
I am at a loss here. I am in desperate need of help.
I am willing to pay someone to come help me allign this saw or diagnose the issue. I don't know what a fair price would be, but let me know what it should be....:(
BTW, I am in Houston-NW side...