Linda Kroeker
02-21-2009, 12:30 AM
Hello again,
I posted earlier in the week about lasering on knife handle material Micarta...I wasn't getting a deep enough laser engraving on the
handles...needs to grip good. So I was wondering if I could just vector cut and not go through the material, would this work and what would my settings be? or a starting point...
I'm clueless on where to start.
I'm also thinking that trying to do this on a 12"x12" piece is going to take forever! Any thoughts?
Thanks again...
Linda
I posted earlier in the week about lasering on knife handle material Micarta...I wasn't getting a deep enough laser engraving on the
handles...needs to grip good. So I was wondering if I could just vector cut and not go through the material, would this work and what would my settings be? or a starting point...
I'm clueless on where to start.
I'm also thinking that trying to do this on a 12"x12" piece is going to take forever! Any thoughts?
Thanks again...
Linda