Andrew Gibson
02-18-2009, 3:30 PM
First off I'm new hear.
Now I have a jet 10" table saw with a 1.5hp motor...
The motor today decided to die.
It will start/try to start. As it starts to get up to speed, it will "get rough?", and stall out at a low rpm.... and has no torque.
I'm not sure what I should be trying in order to get this thing back up and running, as I am trying to finish up some furniture for a friend.
The bearings seem to be fine as the shaft spins easily and smoothly by hand, and there is no signs of burnt parts or connections.
Any help would be appreciated.
Now I have a jet 10" table saw with a 1.5hp motor...
The motor today decided to die.
It will start/try to start. As it starts to get up to speed, it will "get rough?", and stall out at a low rpm.... and has no torque.
I'm not sure what I should be trying in order to get this thing back up and running, as I am trying to finish up some furniture for a friend.
The bearings seem to be fine as the shaft spins easily and smoothly by hand, and there is no signs of burnt parts or connections.
Any help would be appreciated.