View Full Version : ROS Sandpaper question
Dar Lounsbury
01-25-2009, 1:32 PM
I had a 5" no hole ROS that was stolen from a jobsite. I replaced it with a 5" 8 hole ROS Milwaukee. My question is will I cause harm to new sander by using the 5" no hole sandpaper until gone? Air would not go thru dust vaccum. TIA
Dar
Jim Kountz
01-25-2009, 1:45 PM
Look on your sander for vent holes. If it has them then this is where it will draw cooling air for the motor and not through the disc holes. If this is the case then you should be fine.
Bruce Page
01-25-2009, 2:19 PM
No, it won't hurt the motor, you just won't have any dust collection and the paper won't last as long.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.