Steve Lautzenehiser
01-19-2009, 3:02 PM
Hello,
I amnew to the boards and I am looking to getting a new laser engraver. I would like to get the Universal 12X24, due to the 9" material height that I need, although the price is really out of my price range as a hobbyist. I am now looking at the Veralaser desktop 12x16, but it only has a working depth of 4 inches or 6.5 without the table. Why can't I remove the bottom of the cabinet and construct a new lower cabinet with an exhaust port to get a larger working height? I haven't really looked at one yet, so i don't know what is connected to the bottom. Also, does anyone know what the desktop should cost? I've seen a used unit for about 9K, but I do not know if that is good or not.
Thanks for any insight!!!
I amnew to the boards and I am looking to getting a new laser engraver. I would like to get the Universal 12X24, due to the 9" material height that I need, although the price is really out of my price range as a hobbyist. I am now looking at the Veralaser desktop 12x16, but it only has a working depth of 4 inches or 6.5 without the table. Why can't I remove the bottom of the cabinet and construct a new lower cabinet with an exhaust port to get a larger working height? I haven't really looked at one yet, so i don't know what is connected to the bottom. Also, does anyone know what the desktop should cost? I've seen a used unit for about 9K, but I do not know if that is good or not.
Thanks for any insight!!!