View Full Version : chewbarka business card template
fred sanchez
01-17-2009, 6:30 PM
anybody have a template for chewbarka anodized business cards ?:D
Dave Johnson29
01-17-2009, 6:40 PM
anybody have a template for chewbarka anodized business cards ?
Hi Fred,
Just cut one out of 1/8" acrylic. Locate it 1" in and 1" up from the Index corner of your table. Cut a couple of half circles along the long edge so you can get a finger nail in to lift it up.
The kerf from the laser will give a little clearance. I assume it is a standard business card size of 3-1/2" x 2"
Here you go. I knocked this .DXF (Release 10) up in FastCAD in under 5 minutes.
fred sanchez
01-17-2009, 7:17 PM
Right on thanks dave that worked like a charm
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.