Carl Wellman
01-14-2009, 12:58 AM
I have a pinnacle M30 Laser purchased from signwarehouse and it was delivered on January 6, 2009. Very excited to get it and I purchased the Sample Pack from Laserbuzz to try to jump start on my engraving business with the least amount of brain power from myself (ha ha). I have purchased Corel V12 and thought I was ready to go, however, I am having a little trouble.
Using the templete from laserbuzz in corel looks great on the computer screen. When I sent it to the laser the first time it rastered the letters and the stars and cut out only the two outer circles, so I watched the instructional video on the CD again and then I called Tom and asked him a few questions and he stated that all of the templates are vector cuts and I should turn off raster. Made the changes and now none of the letters print out and only about half of the red line designs are engraving and also about half of the black line cuts are cutting.
I have a VERY limited knowledge in Corel Draw as the signwarehouse people do not support Corel Draw and send Laser Magic with their products. I think :rolleyes: that it is a very simple setting that I need to change, but I have went through a lot of stock trying to experiement and have not found the correct setting as of yet.
If anyone has any ideas, I would very much appreciate the nudge in the right direction. Tom at laserbuzz has been great, just hate to wear out my welcome so soon.
Using the templete from laserbuzz in corel looks great on the computer screen. When I sent it to the laser the first time it rastered the letters and the stars and cut out only the two outer circles, so I watched the instructional video on the CD again and then I called Tom and asked him a few questions and he stated that all of the templates are vector cuts and I should turn off raster. Made the changes and now none of the letters print out and only about half of the red line designs are engraving and also about half of the black line cuts are cutting.
I have a VERY limited knowledge in Corel Draw as the signwarehouse people do not support Corel Draw and send Laser Magic with their products. I think :rolleyes: that it is a very simple setting that I need to change, but I have went through a lot of stock trying to experiement and have not found the correct setting as of yet.
If anyone has any ideas, I would very much appreciate the nudge in the right direction. Tom at laserbuzz has been great, just hate to wear out my welcome so soon.