View Full Version : Finishing input please.
Dale Thompson
03-14-2003, 11:34 PM
I've got a few mantle clocks to make for upcoming graduations and weddings. Two are made of Walnut and two are made of mahogany. I'm sure that the Walnut will get about 9 coats of Tung oil (as a turner, I can't stand the thought of a stain on Walnut).
On the other hand, I'm rather new to Mahogany. I would rather not emphasize the red of the wood but I want to give a classy looking present. What do I do?
Thanks in advance:
Dale T.
GEDunton
03-15-2003, 6:09 AM
You like the tung oil finish from your post, so why change horses? It will product as nice a finish on the mahog as the walnut. You can kill the color a little by setting the clocks in your shop window for a week or so, turn them each day, let them sun tan. You can also add a little, just a little walnut stain to the first coat or two or three of tung oil to darken the mahog, when it is darkened enough, go back to clear.
Dale Thompson
03-15-2003, 9:12 PM
GE,
Thanks. I'll give them a bit of a tan when they are ready and we get some sun up here. I've used a lot of Walnut stain on a lot of different woods. I like it but I didn't want to fully disguise the mahogany. Your idea of the "very light" tint is just what I think the mahogany needs. Thanks again.
Dale T.
Steve Schoene
03-18-2003, 8:58 PM
I also agree that tung oil makes a fine finish for walnut, but for mahogany I tend to think traditional and a full finish seems more appropriate. Besides, currently available honduras mahogany is often so very light that it would take decades to reach about halfway to a rich antique mahogany.
If you are a glutton for punishment, I would start with a water based dye, in a medium light lemon yellow color. This will look awful, wet and dry. Then apply a coat of 1 to 2 lb. cut of dewaxed shellac. Then overcoat with a fairly light mix of a brown mahogany dye. The shellac will have partially protected some of the yellow letting it shine through on the denser place where the shellac covered more. Then either use a paste pore filler tinted with a mix of burnt umber (browner) and burnt sienna (redder) colors, or a similar oil based pigmented stain. Then finish with multiple coats of shellac, or if you wish use the french polish technique to finish. Or use any top coat you like.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.