Sharing - mirror stand

[Skip Weiser]

Here's a stand that nicely handles a 12" x 12" mirror with only about a 10 degree tilt to the back. I modified a plate holder that was posted here. Thanks to original poster!

The slots are sized for the .111 thick material that I was using.

Hope someone can use it.

Skip

Happy New Year !

[Leigh Costello]

Thanks! Can't wait to try it!

[Rags Alan Ragland]

Skip
Thanks for your stand. Your timing could not have been better.
Only one question---for us Colonials who do not use metric just how thick is 0.111 in inches? I just made ten of them using 1/16" acrylic and they were perfect for what I needed. Again, thanks and happy new year.
Dr. Rags

[AL Ursich]

Very Nice !!!

Thanks for posting it in V10 for us Corel Challenged users....

V12

AL

[Skip Weiser]

Skip
Thanks for your stand. Your timing could not have been better.
Only one question---for us Colonials who do not use metric just how thick is 0.111 in inches? I just made ten of them using 1/16" acrylic and they were perfect for what I needed. Again, thanks and happy new year.
Dr. Rags

Hi Rags,

0.125 is 1/8 of an inch, so 0.111 is just a little under 1/8".

Glad you folks are finding this useful.

HNY !

Skip

[Roy Nicholson]

That will come in very handy


Regards


Roy N.