View Full Version : Sharing - mirror stand
Skip Weiser
12-30-2008, 2:30 PM
Here's a stand that nicely handles a 12" x 12" mirror with only about a 10 degree tilt to the back. I modified a plate holder that was posted here. Thanks to original poster!
The slots are sized for the .111 thick material that I was using.
Hope someone can use it.
Skip
Happy New Year !
Leigh Costello
12-31-2008, 1:02 AM
Thanks! Can't wait to try it!
Rags Alan Ragland
12-31-2008, 12:22 PM
Skip
Thanks for your stand. Your timing could not have been better.
Only one question---for us Colonials who do not use metric just how thick is 0.111 in inches? I just made ten of them using 1/16" acrylic and they were perfect for what I needed. Again, thanks and happy new year.
Dr. Rags
AL Ursich
12-31-2008, 12:23 PM
Very Nice !!!
Thanks for posting it in V10 for us Corel Challenged users....
V12
AL
Skip Weiser
12-31-2008, 12:43 PM
Skip
Thanks for your stand. Your timing could not have been better.
Only one question---for us Colonials who do not use metric just how thick is 0.111 in inches? I just made ten of them using 1/16" acrylic and they were perfect for what I needed. Again, thanks and happy new year.
Dr. Rags
Hi Rags,
0.125 is 1/8 of an inch, so 0.111 is just a little under 1/8".
Glad you folks are finding this useful.
HNY !
Skip
Roy Nicholson
12-31-2008, 4:47 PM
That will come in very handy
Regards
Roy N.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.