View Full Version : Project Finishing
- Last coat of Satin Polyurethane
- Cat urine
- Tip for spraying EM6500
- oil penetration test
- Maple ambrosia finish
- advice on staining pine
- Sealing Danish Oil
- Gasoline as a wood stain and preservative
- Lacquer question
- Finishing Wenge
- Having a time with pine wood
- Does BLO do anything?
- Spraying questions/advice
- How to remove a black water stain from cherry?
- Finishing Children's Toys - Colorfast Solutions Needed
- hickory table top changed color
- Help with finish over Waterlox....
- Opaque pigmented finishing advice
- Can someone educate me on Watco Buthcer Block Oil and Finish?
- Finishing kitchen tool handles
- New (to me) use for Preppin Weapon sanding block
- back of cabinets / furniture
- Fuji Spray MM4 for EMTECH
- Finishing New Doors
- Red "violin" finish - or something like that!
- Painting trex for a hand rail
- Fuming results
- What should I use as a wood filler?
- Topcoat issue
- Keeping overspray off my eye glasses
- Clear on top of Benjamin Moore Cabinet Coat?
- How long between coats when spraying shellac?
- Best Oil Finish for cedar picture frames?
- sealing surface that potentially has lead paint
- Ceruse finish
- Adventures in grain filling
- Do you have a favorite furniture wax?
- Stearate coated AO and Arm-R-Seal
- Wax Polish Dried White and Cloudy
- TransFast Dye Powder Shelf Life
- Resin in timber
- Tinting GF High Performance Topcoat
- Recommendations for finishing cabinet doors (cherry)
- Putting finish on a trivet
- Recommended Finish for Walnut Bathroom vanity top
- Painting kitchen cabs, prep work and paint selection
- Painting kitchen doors/cabinets
- Can I Poly Over Shellac?
- Floetrol
- Painting Booth in Garage - necessary?
- Finishing Secretary desk
- How do I fix this workbench top finish?
- General Finishes white glaze
- Spray Booth Contractor
- Osmo info ???
- Need Coaching for Enduro Conversion Varnish
- A total disaster I’m open to any and all advice
- Follow-up Question Spraying Conversion Varnish
- Finish for evening out sanded vintage pine
- Target USH3000 Water Borne Shellac
- Waterproofing Plywood Planter Box
- Ultrasonic Parts Cleaner for Spray Guns
- Mildew? Tannin stain? What is this and how do i get rid of it?
- My experiences with wood bleaching
- Walnut Coaster Finish Idea
- what pore filler do you use?
- Finishing safely near gas burning appliances
- air compressor for spraying woodworking projects
- Lubricite 77
- Fuji Q5 Speed Control
- Looking for White Paint Recommendations for Spraying Cabinets and Wainscoting
- Paint Sprayer Recommendatoin
- Fuji SC-1 gun
- UV-curing finish cures in sunlight
- Cure time before handling
- Finish for teak table for camper van
- Marks on Monkey Pod Slab
- Upgrading HVLP
- filling slab cutting board
- Holy Cow.....have not been around here in ages! Question....
- Refinishing Gun Stock
- poly over tung oil ???
- Bona Traffic HD Finish: Use Only Portion of Two-Part Mix
- BLO>Sealcoat>EM8000CV Finishing Schedule Questions
- spray stains
- painting maple burned by saw blade
- best paint for bathroom cabinet
- Control dust before spraying
- finish for barstools
- Removing Water Dye from Wood?
- Material and finish selection for rolling book cart
- Looking for Recommendations on Air Sprayer and Compressor
- Shaker Cabinet Seams Question
- White marks coming through after finish cured (most likely BLO bleed through)
- Matching veneer - possible?
- gloss finish with SW Emerald Urethane
- Why you want the 3M PPS System
- Spray can products
- Add some golden/orange color to maple edging
- Waterlox Original (VOC) not drying evenly
- Miniwax Antique Oil Finish
- Target Coating EM-8000CV Review
- Finishing clothing drawers with SealCoat shellac - sand or steel wool final coat?
- Need Cherry Help...
- Fuji Q5 with 3m pps
- Varnish that never dried
- Which variable?
- Refinishing Issue (Waterlox)
- First Time Spray finishing
- Beeswax Finish Recipes and Techniques
- Pour-On Finish for Sides of Plywood?
- Rejuvenate Old Shellac?
- Mystery- Staining/ Discoloration using BLO
- Lacquer thinning question
- Zebrawood Finish Recommendations
- Protect an Oil Finish
- mineral oil island counter top is like velvet??? help
- Homestead Mission Finish Process
- How do you deal with off-gassing from finishes
- Achieving Uniform Stain With Tinted Shellac
- Best method for stripping flaking finish from kitchen cabinets for refinishing
- Mirror finish from wipe on poly- mahogany table
- Alcohol for shellac
- Steel Wool or Not?
- Under what circumstances do you purposely raise the grain before finishing?
- Old Masters Super Varnish
- Turbinaire HVLP Spray Unit - Gun Needed
- Need Help - Table Leaves Warped While Finishing....
- General Finishes WB dye stain
- Anyone used clearcoat over pigmented primer?
- Waterbase Poly over Watco Danish Oil?
- Cleaning grease from wood before finishing
- Why Shellac?
- Gel Stain Question
- Finishing afrormosia for a bed
- Spray Gun Lubricant
- Uneven Color on Plane Handle
- Non-wood accents in marquetry
- Spray-It
- Odies vs Osmo
- Milk Paint Question
- How to Get Waterborne Finishes to Look Like Oil Based Varnish
- Best finish to achieve protective, satin finish on pine?
- Looks for some Finish advice
- WATCO Danish oil thicker?
- Shellac question
- Applying real tung oil to freshly milled pine?
- Two WB finishing questions
- Abranet for Sanding Varnish and Shellac?
- Typical Compressor size for cabinets
- Finish for concrete forms?
- Finishing Problem
- Sanding Sealer
- How to refinish Titanic deck chair with Spar Varnish / Epoxy finish
- Wood Inlay & Wet Sanding Danish Oil - Bad Idea?
- Is this just teak or am I doing something wrong?
- Finish for a walnut coffee table
- Finishing fourmula
- Lacquer vs polyurethane on metal
- Flat sand or not
- Problem using Ferrous Sulphate on white oak
- Picture frame black
- Chemical and Heat Resistance of Selected Waterborne Products vs. Arm-R-Seal
- Chemical and Heat Resistance Results: Part II
- Cypress
- Spray Help Needed
- Food safe and heat tolerant finish
- Low-maintenance finish for outdoor furniture?
- Sealing soft edges of redwood table
- working with pine wood,,
- What finish is most similar to the "Maloof Mix"?
- Spray Finish Help - Please help me understand
- Paint stripper question
- paint sprayers,,
- Wooden Countertop Finish preferences
- Onadaga finish
- Rub out Target 8000cv finish?
- Best flooring urethane
- Gravity fed gun for Fuji Semi Pro 2
- Critter Spray gun set-up.
- Sprayit sp-31000
- White Spots on Poplar
- What kind of finish to use
- Top coat over mineral oil
- Sanding very tight concave surfaces
- Turbinaire Hose Fitting - Adaptor?
- An Unlikely Success
- Weather Beaten Exterior Door
- Exterior Door Glaze and Stain, or Stain, then Glaze?
- Tips, please for staining/dyeing hard maple
- Finish for Birdseye maple - outdoor shower
- live edge coffee table hard finish options
- Sub-contractor leaves blotchy mess, what to do?
- Spray gun for Apollo Turbine?
- Finishing Hard Maple
- GF White Poly Question
- bead board kitchen cab doors
- Walnut finish
- Is this Shellac?
- Painting over Lacquer?
- Restore hardened brush ?
- Spray Booth Upgraded
- Question regarding Sherwood precat lacquers...
- Rockler Sure Hooks and refinishing cabinet doors
- finishing inside of drawers
- Cerused Oak finishing schedule
- Having a hard time with ML Campbell Resistant
- End grain chess board
- Painting a Plywood Room?
- Direct to metal clear coat suggestions
- Enduro-var II
- Clear Coating via HVLP
- Quick flooring finish fix
- Graco TC Pro Handheld Airless Sprayer
- Stain / Danish Oil Mishap
- Looking for advice on sprayer for SW Sher-wood CAB Acrylic Lacquer. What should I use
- Whitewash finish as a primer coat?
- Painting veneer
- Outdoor white oak project - finish question
- Ready for Finish
- Storing A Spray Gun Between Coats
- Need advice on finishing/restoring small table top.
- Target Coatings Pigmented Lacquer
- Finishing a quarter sawn white oak fishing rack
- What is the black pebbled material on drill press tables like the Woodpecker DP-Pro?
- Spray Finish for Shop Furniture
- Spar Varnish Question (Epifanes)
- GF Water based Wood stain too dark - my bad
- Residual Padauk staining/bleeding through after finishing
- dying wood
- Dying outdoor furniture
- Advice on painting new bed
- stop loss bags versus cheaper drink bags
- Graco TC Pro Handheld Airless
- Red Oak And Minwax Early American 230 Stain Problem?
- Finishing curly shedua?!
- Old engraved wood sign - how to seal and paint letters
- Where can I buy Pre-cat Lacquer?
- HVLP vs LVLP
- Stain, nooks and crannies
- Epifanes
- I have been fiddling with the ebonizing process, and I like it.
- Help with cherry table top
- Revelation on cutting in room trim
- Finishing a Butcher Block Countertop?
- stain and finishing exterior wood door
- Can an oil based stain be used over a water based conditioner
- Ben Moore paint
- Mini gun recommendation for turbine setup
- Outdoor sealer for cedar gazebo
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.