- Best finish for maple benchtop?
- Grain Filler
- Finish for sugar maple nursery furniture
- Finish on Fireplace Mantel
- Wood look finish on MDF
- My new easy storage spray booth
- Wax over Antique Oil for green mantle
- simple spray recomendations for two part polyurethanes over epoxy
- OK. Need to QUICKLY know how to fix this
- Help With Paste Wax
- Guilding the lilly?
- White & Red Oak Finishing
- Wax over polymerized tung oil?
- Should I wax over top my polyurethane finish?
- Rubbing out Zpoxy finishing resin, and scratches.
- how to measure viscosity
- Bar Top
- Ever have a problem storing finished furniture in the cold?
- Quick question on a finish for a high chair
- Finish with Danish oil
- Finish for a carving?
- How to accelerate cure for leftover oil varnish?
- Deft lacquer sprayed over latex paint?
- Wiping Oil/Varnish and sanding.
- Orange is the new Maple
- Storing water-based finishes
- Brushing lacquer....
- Colored epoxy help
- Anyone used this Wood River HVLP?
- Guidance on how to finish my first project - a walnut table
- Cherry
- Want to apply the most natural looking finsih possible
- Danish Oil Dud
- Glue compatibility with T&T Varnish Oil
- Water-based polyurethane - Spider cracks on edges?
- Thoughts on Capspray 75 HVLP rig?
- full strength poly before wipeon
- Finishing Schedule Critique
- Birch Built In Bookshelf
- Painting Kitchen Cabinets
- Oil for Redwood Paneling
- General Finishes High Performance Poly...Had some troubles with it
- Stain and assembly order
- Finish over waxed shellac or not - very confused
- zinsser clear sanding sealer
- spraying arm-r seal by general finishes
- bench bandsaw
- Drying time for wipe on poly
- Glue over poly
- First time questions
- quarter sawn white oak
- Disposal of Mineral Spirts / Brush Cleaner
- Maple Blotch
- Runs on Waterlox 89/88 on vertical surfaces, Help!
- Bit of a problem need help
- Repairing a dark stain finish
- Help with mission finish
- Cabinet finishes?
- Finishing -- white streaks
- Watco danish oil over old masters stain
- Gel Varnish over Oil finish
- Rubbing out arm r seal - satin
- Suggestion for a finish???
- White streaks on Cabinet doors sprayed with Watco satin Lacquer
- Any suggestions what to apply ontop of SW BAC wiping stain?
- Is there a colorless topcoat?
- Pricing finish
- Restaining dark stain lighter?
- Define "HVLP"
- Workbench - BLO vs BLO/MS vs BLO/MS/Wax
- finish choices for cherry kitchen cabinets
- SW BAC Wiping Stain - is it called something else?
- Mahogany finishing and Liberon wax?
- Switch to Mlc envirovar??
- Making a 3d cutting board
- Arti-porin dye for ammonia fumed look
- Waterlox satin final coat
- Walnut Vanity finish help
- Dark stain for Red Oak shelves tips for keeping inside corners blended
- Dark almost black "but not solid" black finish?
- Waterlox Original
- Wet sanding arm r seal
- cab acrylic laquer
- Finish On Live Edge Walnut Bench
- Want to preserve a piece of tree...
- What finish am I removing?
- Lacquer and containers....
- Storage Bags
- Finish for decorative boxes?
- Chatoyance Annoyance
- Oven Cleaner to Remove Old Finish
- Sipo finishing
- Alternative to Toluene for washing silicone after stripping?
- Pratt and Lambert 38 Dull sheen
- Stopping sawdust "bleed" between different contrasts of wood
- Gray Dye?
- Catalyzed poly urethane
- Can I Gel Stain over Regular Stain?
- Redwood burl veneer--question on finishing process for best figure
- Strong fast drying top coat for heavy use tables
- Applying Minwax Polycrylic Minus Bubbles
- durable top finish
- Durable black paint for indoor stair case???
- Refinishing
- Finish recipe for QS Sapele
- What to use to finish a Wenge wood box?
- Critter & Poly
- Stripper recommendation
- Finishing Butternut
- Bar top
- Spraying lots of parts - Turntable/lazy Susan
- High gloss black
- Whats's The Standard(Typical) Finish for Rifle Stocks
- Spraying GF Enduro-Var Problem
- Compressor / gravity feed HVLP users: What size nozzle set do you prefer?
- Water based dye on cherry
- Polyurethane pulling away from edges
- Walnut Slab Coffee Table - Tung Oil? Shellac? - Newb Finisher
- Gronomics Cedar Garden Bed Oil
- Paint/Primer
- "Aging Cherry"
- Cleaning Antiques
- Satin vs Gloss
- Table project finishing
- Philipine/Luan Mahogany Staining
- Spraying Clear Lacquer Techniques????
- Applicator for wipe on finish
- Exterior paint options with HVLP
- Wood preparation for finishing
- Waterlox and Aqua Coat Grain Filler -- compatible?
- Charles Neil Blotch Control
- Walnut island
- 3M PPS Question
- Will plywood be ok outside if painted?
- Deck stain recommendation?
- Finish - water resistant - for the inside of communion chalices.
- Thoughts on finishing kitchen table
- Basics???
- Let me start over.....
- Earlex 5500 vs Earlex 6003
- Waterlox/Walnut
- Solids in finish/deck protection/paint
- Is this doable? Darken and maintain shimmer?
- past wax to protect cauls
- Proper sequence for spraying six-raised-panel interior doors?
- Spraying Outdoors
- First time spraying CV - I need some emotional support :)
- Good exterior paint
- Exterior Door Finish
- Johnson's Paste Wax
- Gluing to pieces that are pre-stained
- Deft Clear Wood Finish on New White Pine Doors and Trim
- Test: waterborne lacquer vs solventborne conversion varnish
- pre-finish to check grain
- Explosion Proof Motors?
- Ipe DEck Problem
- UV Fading with GF HP... please help.
- Best Nail Hole Filler for Natural Pine Trim
- Matching door casing and box beams to hardwood floor
- Getting dark sawdust off of light wood
- Mixing stain/dye & poly
- Kitchen Table Refinish - Enduro Clear Poly - HVLP air question
- Veneer application on a less than perfect surface
- Spraying latex with HVLP
- Nitro Lacquer.....???
- Zinsser shellac as a sealer
- White Cedar Deck Railing - General Finishes 450 Exterior satin?
- Coloring finishes......
- Going insane trying to spray GF HP Poly & GF Enduro Clear Poly...
- Maple colored with pyrogalic acis and ammonia
- Finishing the inside of drawers
- Ambrosia maple blotching
- Behlen's Rockhard Table Top Varnish
- Water-resistant finish for plant stand
- Customer finishing project?
- sanding off the stain between coats
- Anyone with experience with WATCO Danish Oil?
- How to find a Professional Finisher?
- Protection ability of pure tung oil and minwax paste finishing wax?
- Finishing Walnut Table
- Stickley like table
- Abralon & Surbuf for Rubbing Out finishes
- Apollo Precision 5 System
- how to finish a walking stick?
- Buffing Wheels
- Should I use polyurethane, or something else?
- Deft step saver ?
- Breakdown Spray Booth
- wood floor finish, polyurethane
- vinyl decal under finish?
- Strippers.
- Water based clear finish question
- At wit's end with Varathane "fast dry premium stain"
- Finishing Mappa Burl Veneer
- What's a good way to blacken Maple.
- Clearwater Gel Stain
- Spray room bug control
- Pressure of Apollo Precision 5 Turbine
- Small parts finishing
- Spray Technique Question
- Waterlox help
- Unfinished Maple - Need Advice
- Matching Acacia Flooring....
- How do I get this finish? Good online source for this technique and products?
- Buffing final top coat
- De-Waxing shellac
- help finish a dining table/workbench
- Tung oil for exterior table?
- Looking for advice on a paint gun
- Best Way To Apply P&L 38 (?) To Spalted Maple Table? (Pics via link)
- What finish for dinning room table
- Need Help Determining Best Way To Tint Existing Kitchen Cabinets
- finish suggestions for white oak coffee table?
- Tiny Bubbles, Not In My Wine...
- Finishing with wax?
- Mix MinWax Stains?
- Sand between coats of alkyd wiping varnish?
- More poplar finishing problems
- qswo
- Filling nail holes in mdf trim
- Poly/Lacquer interaction?
- Is this "Orange Peel"--and Now What?
- Fast(er) drying exterior finish for Ipe
- Bathroom Vanity
- Finishing Birch
- 3M PPS System...Anybody Use It?
- 2K Primer - Recommendations?
- Spraying ML Campbell Augelente
- Colorless Sanding Sealer
- Can I rub out wiping varnish?
- Chestnut Finishing Oil
- Best rattle can paint for used bar chairs.
- New cedar need a cleaner?
- Shellac & Tried and True
- Need help with teak on a boat
- Recommended Finish for Trivets?
- Waterlox vs. Murdoch's 500 finish
- Large south facing windows vs my future furniture.
- Pre-treat Brush With Appropriate Solvent Prior to Use
- Airless sprayers?
- need help refinishing table
- Sticky Table
- getting ready to paint cabinets
- Graco Sprayer is out, Now what? HVLP, turbine....Lost
- Ammonia
- Varnish over oil varnish finish
- Waterlox wood prep
- Thinning Deft Lacquer Sanding Sealer???
- Compatibility of Z-poxy pore filler under an oil stain
- taking glossy varnish to satin..