View Full Version : Project Finishing
- Gravity gun vs. siphon?
- Finishing a Custom Silverware Drawer
- End grain cutting board
- How to get this color
- Need A good Sander/polisher "Rotaion slows down"
- Wax On Wax Off
- Removing varnish/lacquer/poly
- I wonder... Cyclone as a spray booth ??? Crazy????
- White Waterborne Lacquer or Poly I can trust?
- Latex paint on wood - Can I buff it?
- Thinning with mineral spirits in cool weather
- Repairing Tearout after oil/varnish
- Box store's finest wiping varnish
- Easy Finish for Christmas Ornament
- Help! Can't lose the scratches!
- Tung Oil on white pine ?? to get that yellow golden old log cabin look
- How long after waterlox?
- What is advantage of spray system that comes with turbine vs. using air compressor?
- How many coats of Waterlox on red oak handrail
- Waterlox Questions
- walking cane finish
- Final Coat question
- Red oak-need grain contrast-waterborne?
- glaze technique with Mission style finish
- Painting MDF
- Spraying lacquer and having a time!!
- Help! Cherry top partially faded mid-project.....
- Which gravity HVLP gun?
- Dark Finish Even Coverage
- Light- colored grain in ebonized red oak
- Pratt and Lamber 38
- Waterlox VOC Compliance
- water based stains
- How Humid is Too Humid?
- Waterlox FS over Waterlox Satin?
- Conversion Varnish Recommendations
- Do you finish parts before assembly or after??
- Given a choice, polyurethane, shellac, or lacquer, which one??
- Bahlen's Rock Hard
- Black primer not sticking to nickel finish hinges
- Penetrating Oil Products
- Removing dust nibs in final coat of waterlox original?
- Wooden counter top finishing suggestions?
- First time user of aniline stain - water based
- What is it and how should I finish it?
- My em6000 is blue
- Sher-Wood Acrylic Conversion Coating Vs Precat Lacquer
- Question on bubbling from lacquer
- Antique Pine Finish
- ? Interior Varnish on Covered Exterior Door??
- How should I finish a butcher-block cart?
- Hand painting a cabinet door
- Storing finish materials I.E. Waterlox
- shellac top coat after grain filling confusion
- Deer Antler
- Waterlox SF vs Arm-r-cell
- Kitchen Table Finish
- New to finishing need some direction
- Fuji Q4 Pro Electric consumption?
- HVLP spray gun cleaning and lubrication
- Unhappy with results of floor refinish
- Finishing NYW router table
- Method of BLO/Poly
- Can I use General Waterborne over Target WR4000?
- Spray booth
- Suggestions for kitchen cabinet finish
- Help with flush veneer door slabs
- Dissolved shellac top coats: What's your procedure to final surface
- Getting a very dark finish on Walnut
- Do I need to sand after applying Target Coatings WR4000 before first coat of topcoat?
- Finishing a pine dresser
- Red Oak doors, what finish should I use????
- Coating with epoxy is not flat
- Painting the edge a different color
- Outdoor Finish
- 3m gold sandpaper...stearated?
- Best Finish for a Bathroom Vanity
- What finish for teaspoons?
- Goofed on sanding birch plywood
- Shellac Problem
- Dewaxed shellac vs. non-dewaxed shellac
- Painted cabinet for customer
- "Cherry" Finish question
- Please recommend a latex paint sprayer
- Question for You Finishing Experts
- Amber (orange) shellac and UV
- Finishing a new pine kitchen table
- Finishing lots of small pieces
- To stain or not to stain: Birch shop cabinets
- HVLP gun: gravity vs none
- Linseed oil help
- Spray booth Filter/Regulator recommendations
- "Lint Free" rags.....ARRGGGGGG
- Candle stick holder Finish
- Dip finishing.
- DeVILBISS DeKUPS Disposable Spray Gun Cup System
- Fuji Q4 HVLP Sprayer
- Staining Just the Tips of Box Joints?
- Little hint for EM6000 users
- Black Finish Options
- Aghhhhh!!!
- Maple countertop finish question
- BLO Help
- Recommend me a turbine HVLP Gun
- formica over plywood, small voids a problem?
- Do I need to seal sapele before applying filler
- Finishing curly maple
- What kind of finish should i use
- Another Cherry blotchy problem
- HVLP guns
- suggestions needed for removing alkyd paint off plantation shutters
- Ready to tackle those bathroom cabinets and need refinishing help!
- wipe on poly to go over shellac levelled finish?
- finishing a red oak Mantle and need advice
- How to prevent marks from bench cookies on varnished top when finishing other side
- what finish to use on bucherblock
- Talk aboiut feeling stupid......
- Help with mahogany Door - pores showing in varnish
- Recommended stain for natural walnut finish
- matching stain, spraying and topcoat choices.
- Finish for cherry staircase
- help with touch up color in QSWO after transtint dye
- CA glue as a filler/finish
- White woods
- Grain Filling and finishing Red Oak plywood
- Grain Filling and finishing Red Oak plywood
- Why is Poly Varnish Bad
- Spray finishing a built in unit
- Behlen Rockhard for Gun Stock?
- Refinishing Cabinet doors
- End Grain Cutting Board Sanding Question
- another question
- What's going on with this finish
- MiniWax Oil base stain
- Will brushing lacquer burn through miniwax stain to old lacquer
- spray tip for GF stain
- Target EM2000
- Recommendations regarding stain for Poplar?
- Base - Sink Door Finishing Question
- Festool Finish Sprayer???
- hard and soft maple in same project?
- Help Refinishing Dining Room Table
- Finishes that won't combust
- Hello! and some questions about a current and former project
- Restaurant table tops - long
- Staining Advice Question
- Refinishing cribbage board from oil+paste wax -> wiping varnish = problems
- BLO on MDF--How much is enough (or too much)?
- Wood Bleach
- Minwax polyshade
- Questions on building a white built-in
- Target Coating EM6000 question
- Minwax Polycryic water based spray
- Pin holes in red oak finish
- W. Red cedar void filling?
- honey oak
- "Hand Rubbed": What does it mean to you?
- Wipe-on poly over Bullseye Amber shellac
- finnishing a cane seat chair
- outdoor finish
- Brands of various types of varnishes?
- Masterpiece finish
- Way to reduce 844 colorant strength?
- What do people prefer to rub out a varnish finish
- SLX Denatured Alcohol
- Does anyone else do a dead leve/glass smooth glossy finish? Anyone use a burnin coat?
- What can this be?
- Can I rub out water based Poly?
- What to topcoat over Watco?
- Darker finish for cherry?
- Mineral spirits, paint thinner, turpentine, which and why?
- Readily Available Water Based Products that meet KCMA Performance Standards
- Spraying WB Poly; questions from a new sprayer
- how many urethanes?
- Milk Paint
- Workbench finish
- Topcoat for Unfinished Soft Maple Kitchen Cabinets
- Finishing breadboards ends
- Sponge sanding pads
- Recommendations on Bookcase Finish.
- A tip to share.
- Best match wood filler for white oak?
- Refinishing a very old desk top ...
- How to deal with Orange Peel and only partially filled pores with Waterlox
- Refinishing Question: Removing old stain/dye
- Polyurethane over Waterlox ???
- Making curl pop LESS
- Removing a dent from Honduras mahogany
- Removing Poly from flooring...
- How do you mix small quantities of dye?
- HVLP Wainscoting Satin Impervo
- Oil varnish blend over dye stain.
- Quick and Dirty Stain for shop table
- P&L #38 over Waterlox?
- invisible finishes.
- Wipe-on Waterlox Satin Question
- Shellac or dewaxed shellac?
- Painting Pine?
- Help with finishing Cherry
- Target Coatings promo code??
- Tanning Cherry
- Using Clamps with Plastic Protectors
- HVLP Spray Guns: Which is best for under 150.00
- milk paint questions
- Alternative potential sources for Ammonia
- What is commercial "clear" shellac equivalent to?
- Soft Maple looks dirty on parts of boards after planing. Not Plane marks.
- Will BLO Darken Curly Maple?
- Spraying Shellac on a crib
- My experience with Waterlox
- Looking for VOC's in Las Vegas
- Finishing Endgrain Maple
- Walnut Oil
- Lengthening the shelf life of finishes
- Finish for a usable goblet?
- Spraying EM6000 w/Earlex 5000 ?
- Fuji HVLP Problem
- Shellac help
- Blemish on Epiphane finish of Mahogany door
- Help with brush on finish for kitchen cabinets?
- Arm-R-Seal questions
- Overlap marks with leather dye
- I'd like to try spray finishing but.....
- Help: can I varnish over glaze? or, what is happening to my doors?
- OSB Board
- Shellac flakes + isoprophyl ?????
- Clear finish for curly maple???
- Walnut coffe table - need a new finish option
- dust collector bags useful for finishing?
- Finishing Pine
- Dog Dish Finish
- Fast Drying Dipping Finish?
- Danish Oil as Topcoat
- Boiled Linseed Oil
- Reducing gloss of oil based paint?
- Anyone Using Hydrocote Resisthane?
- Finish needed for bar top
- Sealcoat instead of primer
- Milk Paint question
- Oak Award Plaques
- Removing Glue to Re-Glue
- First time using Earlex 5000 HVLP-Shellac or Poly over transtint?
- Advice on staining oak plywood
- HVLP Turbine, Which one to buy?
- How many coats of lacque.
- Questions on finishing desks for durability and beauty, by a novice
- Has anyone used Vermont Natural Coatings?
- Removing Varnish Drip on Bottom of Table Top
- Finishing MDF with Polyurethane
- pre cat lacquer or waterlox
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.