- Another Spray Gun Question...
- Danish oil on pine...will it be blotchy?
- refinish question
- Rubadub
- Which finish?
- Finish choice help
- critter air powered spray gun
- Filler on Bubinga
- BLO vs Shellac on longleaf pine
- pre-cat lacquer sanding and blemish fixing
- bumpy finish
- Knock down finishing booth and lacquer is on the bookcase!
- How many finish coats to use on a desk top?
- Wagner HVLP gun fix help!
- Western Red Cedar outside
- Removing Finish
- Finish for an exterior Oak door.
- how to degloss waterlox
- Wiping down project
- Conversion gun or earlex 5000
- Best sandpaper for WB finishes?
- Finish for butcherblock vanity top?
- Extremely difficult paint problem
- Finish for bottom of cedar fence posts?
- Outdoor Finish for Teak Cabinet
- Acrylic Painting (fine arts) on Furniture?
- Brushing shellac on pine...
- Now what gun to do the finishing with...
- Sanding Paste Filler in Oak????
- Thanks to all for the help
- Lacquer question.
- BLO: worth the wait?
- Varnish as a cutting board finish - soaking in?
- Outdoor Patio & Deck stain question
- Aniline dye, shellac, and mahogany
- Removing Paint From French Doors
- Walnut Burl veneer finish
- Under paint wood filler?
- Fixing burned wood.
- Uneven finish on Oak Plywood
- Painting Wood Doors
- Poly/Shellac Finish Question
- Staining reddish walnut to look more like chocolate walnut
- Finishing Nogal
- Em 6000
- Bamboo end grain parquet butcherblock for a kitchen countertop...
- Trying to Match Wood with stain
- "Bar top" finish choices?
- Protecting painted surfaces
- Spraying help needed
- Finishing a Cherry Desktop
- Re-staining stained & lacquered cabinets
- Spraying Question
- whats a good natural finish for mahogany?
- Kitchen Finishing--check my thinking here...
- New guy needs help
- pocket holes?
- Emtech 6000 with Mixol and other questions
- Deft Brushing Lacquer help?
- Brushing Bonakemi Mega on stairs?
- Sticky Stain
- Any one using ITA catylized finishes
- Planes, sandpaper, pores, and walnut
- Here is How I am Finishing That Box
- Fill grain with shellac before dye?
- Burl Crack Filler
- When to raise grain?
- Mohawk Pour and Wipe Finish
- Staining Sipo for exterior hand rails
- How would I repair holes in an 100year old hardwood floor?
- Capspray CS10000
- Capspray CS10000 HVLP
- Do you use wood conditioner when staining pine?
- Best way to darken soft maple well and then seal. Stair Tread
- Sanding between varnish coats
- Box Lid Making a Dry Curl
- polyurethane kitchen table problems
- Wet Sanding Seal-A-Cell
- advice needed with beech wood
- Linseed oil shelf life?
- Finish inside of carcase?
- HVLP turbine alternatives (DIY)
- Darkening shellac finish?
- Tried and True Original wood finish on cherry
- Filling Knot holes
- Best stain for pressure treated wood deck?
- Transtint dye with Arm-r-seal oil topcoat?
- Water based lacquer
- Advice needed: Shellac Vs. Varnish for cherry bookcase
- Using Solar-Lux
- hook & loop sandpaper sheets
- danish oil not drying on red oak
- Splotchy antique finishes
- Tinting Oil Based Polyurethane
- Spray Booth
- Refinishing / Finishing advice needed
- Black Finish for Oak Desk?
- Cleaning poly finish before last coat
- Premium sandpaper
- Poplar
- Finish suitable for washing and disinfecting?
- First finishing job going south
- Wood filler on PT to be stained or painted?
- product reccomendations for platters and tables
- Salad Bowl Finish in Canada?
- Can I tone down outdoor Marine High Gloss Epifane finish?
- Sanding between coats of Poly
- How do I get a dark almost-opaque finish?
- Waterlox Finishing Schedule
- Pine door scratches
- Canned Shellac or Flakes?
- Accuspray 10 gun
- Bar Top Finish
- Lacquer and bubbles.
- wax over arm-r-seal?
- Glazed white kitchen cabinets procedure?
- Refinishing Red Oak Coffee Table Top
- ''Greasy'' coffee table....?!?!
- mottling of varnish
- Hybrivar over USL
- Walnut finishing ideas...
- Types of stains? Multiple coats? How Long?
- Blotch free cherry finish
- Zinsser SealCoat in California?
- Oops
- catalyzed lacquer turning milky - any know fix
- How do I remove wax from a lacquer finish?
- Spray Booth Exhaust Question
- Differences in stain quality
- Will paint gun handle oil primer?
- My First Spray-finishing project...DONE!!
- Does japan drier 'go bad'?
- staining ash end grain
- Coffee - colored Coffee Table
- Leveling Water Based Poly
- Matching new walnut to old
- Shellac questions
- Finish questions for African Mahogany and Bubinga Table
- dining room table finishing
- Rechargeable aerosol cans
- Shellac clean up?
- Shellac ??'s
- Clothes drying rack...
- Arm-R-Seal over gel stain OK in a bathroom?
- Brush or Airless for Doors and Cabinets?
- Spraying shellac
- Vapor Mask Good as a Dust Mask
- Finish coat sheen?
- Satin, Semi-gloss, or Gloss
- Staining Poplar and Birch
- Okay - I have to ask...
- In Desperate Need Of Help On Polyurethane Mirror Finish!
- Scotch Brite pads on an arbor
- Fast and Beautiful finish on Walnut
- Finishing w/o any Color Change
- Baby safe finish for walnut or cherry
- Getting that "dark cherry look"
- Watco Oil with or with out Buffing Wax
- Masking Clean Lines with Dyes
- Finishing Padauk
- Gel Stain and Tung Oil
- Any Advice on refinishing this piece
- Mineral Spirits or Paint Thinner
- Maple workbench.
- Stabalizing spalted maple chest
- Need an opinion...
- Experiences with CrystaLac Grain Filler
- Vapor Barrier for Laminate Floor
- Arm-R-Seal Shelf Life....dancing with the Devil
- A really tough PAINT or OPAQUE STAIN for MDF furniture?
- Ammonia fuming advice sought
- Milk paint?
- A little finish booboo
- Water based lacquer over Waterlox?
- Sanding and painting question
- How do you keep Waterlox fresh?
- Finishing cypress
- Emtech 2000 (Hybrivar) experience?
- Mahogany Finish
- Outdoor Bar Top Finish
- How to do a Fire Blacken wood finish?
- Tips/air caps for accuspray gun
- Simple Finish for Paduk
- Finish on coasters
- How long should I wait to wax a tung oil finish
- Thinning ArmR-Seal
- Pardon my ingorance
- Stair treads
- Linseed Vs. tung oil on strat neck
- Finishing Poplar Desk/Drawers
- tacky finish?
- advice needed for filler and finish for furniture made of Ash
- Water based finish over Waterlox? Possible?
- Can I use white shoe polish???
- Waterlox Alternative
- Oak Cupboard Finish Enhancement
- What furniture parts should be left unfinished?
- Spraying with SW Proclassic Acrylic?
- Finishing curly walnut kitchen table
- Help with carnuba wax leaving white behind
- Dull Finish
- HVLP painting
- Medium dark finish for hard maple?
- Shellac over Cabin pine interior ??
- Problems finishing w/ cocobolo inlay
- valspar wb lacquer ?
- Tung Oil Tinting
- French polishing: first attempt
- Washcoat & Stain Question
- GF Enduro acrylic
- Finishing memory box question
- Finish Type Opinion Needed
- First Time w/ Cherry & Makore
- Want a CLEAR finish
- Anyone use Gel Varnish?
- Spray Rock Hard?
- EM6000 - how long before finishing the finish
- linseed vs tung... a new question (hardy-har-har)...
- Valspar Zenith
- Is it done yet?
- Old Driftwood Finish
- Between coats prep of BM alkyd SI
- Is this the right Mineral Oil for Cutting Boards...
- Alternatives to Latex for HVLP
- Good sprayer for applying stain?
- Spraying Transtint Dye?
- Scotch-Brite pads
- Final Coat on Table Top
- Asturo WB gun - Pressure feed or Gravity?
- Target Water Base USL Crackle
- Walnut hole filler
- Closet shelf finish?
- Shellac Finish
- Refinishing project - mold (I think) stains
- Best finish for "Dirty" wood?
- Gunstock finishing
- A few (more) Shellac questions....
- Best options on this---anyone?
- Finish Selection Tools
- Water???
- How to Rub Out Behlen's Rockhard tabletop?
- Problem spraying Laquer.
- Oak Doors
- Workbench Finish opinions
- Spraying Shellac - which tip?
- Photogenic Wood Finish
- regaining open-pore appearance in oak
- Stubborn bubbles in poly
- Waterlox on Ebony cabinet
- Waterlox as a wipe-on, wipe-off?