All veneering needs to be balanced. You have a core and a layer on both sides in the opposite direction if everything has a grain. Eliminate a layer...
I know this thread is a couple years old but I just wanted to add that I have a 1000, 6000, 10000 and 13000 Sigma Power (not select) which are fired/...
Once heard he folded the bill of his cap and rested it on his head so it would be blown off when he went to catch a ball just to give the fans a bit...
Putting the same veneer on both sides of the backer is a good idea. Alternating the grain a little or a lot could help too. A long clamping time and...
When you drill the hole for the anchor drill completely through the floor. Set the anchor as you normally would, to anchor the machine.
When you are...
I got a little time in the shop today after lunch; most of which was taken by milling some ash for trays that will go in the drawers as well as some...