Activity Stream

An 1/8" cut is out of the question for nearly every lunch box, and many have issues taking 1/16" at full width.

Thanks for posting this Stan! Very informative for a multi-board setup. David

When I used to work on Aircraft in the Air Force, we had assigned tool boxes with foam cut outs. Each Airman had a set of tags we called Chits. We...

Essentially you are buying a box with a blower. The question is what filters are you putting in the box and what filters can it handle. I have a...

+1 on John’s suggestion. I have similar castors under my Stinger table and once the pads are jacked down they are rock solid.

I have a Grizzly air filter and a homemade from a furnace blower, the homemade one is by far the best one. I have it mounted on the ceiling with 3...

I like it. It’s a very good looking piece.

That is very interesting Ron and proof just how individualized all this is. A good PT is so valuable but I really don't want to have to deal with...

Wow, lots of good information. Will start investigating all leads. Thanks to all. Randy

Kevin, I believe Rod’s comment relates to the fact that in many (most? all?) cases the dado precludes the use of the riving knife, hence the need...

Don't know about the commercial units but in my 2 car garage shop (about the same size as yours) I have a shop built unit using furnace filters and a...

I too suggest you have a look at Richard Raffan, his latest set of videos are mostly done in real time and his explanations and visual presentations...

Thank you Ralph. I just sent you a PM.

I had shoulder surgery on my right shoulder 8 years ago. Turned out great after a LONG recovery. My left has been bad for a year off and on. I...

The harbor freight and grizzly lathes were direct copies of the Jet 1442 IIRC. I think the quills for the Jet 1642 and the Pm3520A were the same....

That wording never appeared in my research. Current yes. HP no. In my research, those that measured and provided the differential never had numbers...

HI Jim if this is still homeless I'll take it.

These are the locking/leveling casters on have on my cabinet. They are very robust, and the leveling feature is a must IMO to make sure the bed of...

I can glue, clamp vertically one or 2 at a time. Build up to full size. Thanks everyone I will pass on the screws, when I've used biscuits I've...

Stunning piece and execution! I should be so lucky with a mistake!

I thought it was common knowledge that carbide insert heads take more horsepower than straight blades.

PB blaster is also a good choice for cleaning them

If you only need one or two pieces make a scratch stick from the profile. Waste away most of the wood on your tablesaw or router table and then use...

Well done!

Explain how screws help alignment? You would get better alignment with a saw kerf and spline between the boards.

Sent you a PM.