Activity Stream

I think it is because I don't have the mouth wide enough yet. Looks like you were typing to me while I was typing to William. OEM with the...

Thanks to your first and subsequent post, I'm a proud new owner of the King J/P as well! Would you mind posting a couple of pics of your igaging...

Michael, Paul has built a huge ... huge ... following out of those with a desire and little funds. And it is a business. He earns money from this....

It is expensive but I may give it a try.

I agree. :)

To get the look of an oil based varnish with water based products I've had good luck using Sealcoat shellac first, then the WB varnish. EnduroVar is...

Likewise, but I allow for some spindown. It works out to rarely cycling the power more than three times an hour, typically.

Thanks William. I love seeing your posts when I am searching older threads here. I did double check your advice above. I spent quite a bit of...

Thanks for the replies. That is something to try for getting iron stains out of my toilets. jtk

Ernie, smart move....

With the chip breaker about 3/16" back from the edge is the 0.004" shaving the thickest shaving you can take? Is the depth at the end of its...

Thanks Andrew

Back in the 70’s some Datsun dealerships used Dow Corning 111 for this purpose. It rocked, and I still use it to this day. it’s an industrial steam...

Nice choices! It looks like you've already put them to some good use, I'm sure you will enjoy using them for quite some time - these newer steels...

I've not tried it yet, but a ton of people swear by Mirka Abranet, It's like abrasive on a screen and doesn't build the heat like cloth backed. I...

A very low angle wedge (or 2)? Probably be just as easy pulling them out when you want to move the cabinet as unlocking the wheels would be. Not...

Thanks Jim. I've been following your high praise of EM8000 but I can't find a Canadian distributor and our borders are closed to travel. Will the...

Rod, I am up to 57 years with a few breaks along the way when I temporarily thought "quitting was a good idea." Those breaks didn't last long and I...

What Jim said. 10” blade goes 3” deep both sides so you got 2” to cut and the table saw kerf guides your saw.

What is different about the metric vs imperial? My guess, and it is that, is the thread pitch of the lift is different, similar to the Incra TS-LS...

Supposedly the Enduro Var can't be used over shellac, just raw wood and water based stains and dyes. Definitely test it first. I wasn't thrilled...

EM2000 is really nice. But yea, ALWAYS test anything on scrap of the same project first and that test should be every step.

I would love a stroke sander but I would have to build a bigger shop. I am going to try some of the tips here. I can go back to a hand plane and...

Researching the above mentioned woods: IPE- possible toxicity Lignum - Good stuff if available is $$$$ and not environmentally friendly right...

Does anyone know what is metric about the metric version of the Incra/JessEm table? Is it just different labels on the read-outs or is the table or...

This is how I did my DC setup using the 3HP blower, steel SDD, 35-gallon plastic trash can, and a pair of Wynn filters. My basement ceiling height...

My experience is that getting a one-off of anything made, from any kind of shop, is going to start at $100 and go up quickly from there. If it...

When the chip breaker is 3/16” back it is doing basically nothing. At a 1/16” back and no shaving it may be jamming the shaving. Check the fit of the...

Roger, while we certainly did a lot of work and research ourselves for our property search in the last month or so, our realtor has earned his keep....