Activity Stream

The one thing you don't have (directly) using the DC for collection from the ROS is the ability to reduce "suction" as you move up to finer and finer...

Yes but doesn't have data logging. It will tell you what the particle counts are as they happen just the same as looking at a Dylos. It uses the same...

Excellent, thanks Phil. Best, Chris

Ok, clean up done....Installed that new saw blade in the tablesaw... And made all the plywood panels...once I remembered which way the grain was...

This is cute. Would it have any value?

I agree with John. Cherry is not a good choice for what your customer wants. And honestly, that includes the original "gray" choice, too. And no-way...

Get a cheap paint stirrer for an electric drill. I never want to leave machinery running, unattended, for two hours.

You aren't turning on the back side are you?

Best of luck with the surgery - hope you come out like brand new!

Lets see...rebates needed cleaned up on the corner posts.. Mainly the ones to house the back of the case...set up a pattern, to cut a detail ...

Can you make a jamb chuck instead? Why do you need a tube?

You are correct: LN irons with no markings are O1, the ones marked are A2.

Deleted offending posts and references to them. Another reminder: play nice here. Don't call into question someone's ability or be unnecessarily...

Could you just make a wooden box instead of using PVC?

Sounds like a recipe for disaster. I hate to imagine what would happen if something comes loose and poly spills all over the place. Play it safe...

Al, you got it right. in my case, since the supported part of the board was 8", and the overhang was about 4", the planer rollers held the board...

Not really. I work from home so it would be a snap to pop down to the shop, set up the lathe and go back to work for a while. Then the varnish...

Your actually paying about $800 more for extra HP and weight while sacrificing length. If I had $3K to put on a lathe, it would've been the 1836...

Someone did a study comparing the topography of my home state of Kansas with that of a pancake. They determined that if you were to shave off the...

Your story is why I always get a deposit up front that covers at least the cost of all the raw materials. In my world, she would now own that cherry...

Almost sounds like a solution looking for a problem...:) Regardless, a couple hours seems excessive. Seems like less than 15 minutes would be more...

"Christopher, I have many LN planes, some unmarked and some with their name. I wouldn't bet the house on it, but I believe the unmarked blades are...

Hello Simon, Thanks for the additional details. I do almost all my honing freehand and over the entire bevel. Where I was mystified over the notion...