Activity Stream

Here are the DB levels with a background ambient level of 35DB. My system is a CV1800 with a 15" impeller and all the gates were closed during the...

I have one of the Powercrasft saws. Srill in use on and off when I’m working up at my camp. That’s where it’s migrated to simply because it does...

I purchased an insert set from Whitehill Tools and think highly of it. I think Infinity sells a set which might work for you.

I would make them out of any stable wood , meaning here : stays straight, then treat them with copper naphthalate . The kind that is NOT oil based. ...

John, Another choice is white oak. It is extremely weather resistant and rot resistant. It is used in boat building for that reason. I listed...

No, it is much worse. The picture doesn't really show it well enough because I couldn't get the lighting right.

never on 4 fiber lasers over 6 years have I seen an 'agree/disagree' dialog--- could be your program is corrupted or whatever... Also, the IPG-YLP...

Yeah, I meant -10% and yes, Vanguard is an excellent trustworthy company. Do be careful with their mutual funds, as the market can go up and the...

To When buying a VFD always make sure it has vector control to prevent torque loss at low speeds. Low speed also affects motor cooling so that...

Will see how it turns out.. Once the 19 clamps come back off... In the morning.... Stay tuned...

Only on a dedicated circuit.

Jim's suggestion is on the money. When my cast iron shop machines need a refreshed wax treatment, I use mineral spirits to remove the wax. It takes...

It's not the current per se – rather it seems to be the inrush current when turned on that trips AFCI.

Aren't you allowed to just go up a size if the breaker trips? Seems like you'd be narrowing down your options by requiring a soft start for any...

Another old saw: "A fool and his money are soon parted."

Thank you all for the feedback. We have a solution in the works !

Mike, if you're happy that's all that matters. 12 ksi is half of where the Woodmaster CT performs best. Your photos shows it still performs well,...

I would not buy that.

I think the thing to do here is pick one plane, I would reach for a #3 or a #4 if you have one of those, and then practice on construction lumber. ...

I thought a beam with a sensor at the opposite side might work but the I reject that idea because of the dust issue. The one we made had a LED bar...

I'm sure you'll get some more knowledgeable responses soon. I've had to handle some similar tasks of removing a taper (and putting a taper on). I...

I think a better approach is a bigger impeller and run it at a slower speed but that will never happen. The cyclone won't be any bigger or if it is...

Yep. This wasn't an envelope I pushed intentionally, but there are some folks around who use more shellac than me. My current plan is to let...

Holy cow, about $900 for that. It looks well made and maybe it has its place for folks who only need to make small quantities of veneer, etc, and...

I too have never used a gauge on a blade. On my Aggi i have my blades cut and welded 178 inches because that’s what it says on the saw and tension...

I currently have a 3-phase motor waiting to be swapped for the single phase on my Clearvue, just need to get a VFD and make the time to work on it. ...

I never fully tension either I get good results as well, don’t know about more hp helping or not but more mass in the wheel would help throw the...

Bigger, highly contoured, anodized, engraved ... 'Value added. Profit is always a percentage of 'cost of goods'. You wanna spend all your spare...